MAXRemove Instructions/DirectionsUpdated a month ago

Apply MAXRemove to a cool surface, and do not apply in direct sunlight. (Note: Water spots must always be addressed immediately to reduce chances of etching into the surface. Once water spots have etched into the surface, the surface will have to be repaired by using an abrasive compound.)

1. Using a dilution bottle such as the MAXL Dilution Bottle, mix MAXRemove to desired ratio according to the guidelines in the Dilutions chart below. 
2. Rinse off large debris such as mud, with water. Spray MAXRemove directly on surface, apply liberally - use on all exterior surfaces (paint, glass, chrome, wheels, etc.).
3. Let sit on surface no longer than 2-3 minutes and never allow product to dry. If drying starts to occur, rewet surface with more MAXRemove, or a fine mist of water.
4. Rinse thoroughly with water until the surface is no longer sudsing. For difficult areas such as heavy staining, hard water spots, etc, multiple treatments may be required; and/or, physical contact may be needed to help dislodge particles from the surface.

5. Wash with a pH neutral soap such as MAXWash to remove all final residues and any remaining MAXRemove.

*Ratios: Add water first, then add MAXRemove. For example, 4:1 means add 4 parts water to the dilution bottle until it reaches the “4:1” mark, then add 1 part MAXRemove and fill to the “fill line” marked on the dilution bottle. 

Tips: Spray MAXRemove into a MAXL YellowCell Hypersoft Wash Sponge, MAXL YellowCell Hypersoft Mini, microfiber towel, synthetic clay/decon towel, or applicator and wipe the area. To reduce chances of scratching or marring the surface, do not press down too hard while wiping, and be sure to use a soft towel or soft applicator. After using, remove trigger sprayer and screw cap back on bottle tightly. Run clean water through trigger sprayer to prevent clogging inside of trigger from occurring. Can be used in a mister or foam cannon. Bottle is designed to fit popular foam cannons (bottle may not fully seat).

DO NOT USE MAXRemove WITH A CLAY BAR AS IT WILL EAT MATERIALS IN THE CLAY BAR.

Important: This product may build pressure and vent. Upon receiving, rinse and dry the bottle thoroughly before placing on any surface to prevent potential stains. Wash hands after handling. Store using the white vented cap provided. If using a spray trigger, rinse it with clean water after use and replace the white vented cap for storage. Store in a cool, temperature-controlled area to minimize venting.